IANCHQU= anchor items interactively = No

Items to be anchored can be entered interactively by setting IANCHQ=Y. If you specify this, you are asked if you want to anchor any items. If you respond "yes", it will ask if you want to read these anchored items from a file; if you answer "yes" it will ask for the file name and process that file in the same manner as if IAFILE= had been specified. If you answer "no", you will be asked to enter the sequence number of each item to be anchored, one at a time, along with its logit (or user-rescaled by USCALE=, UMEAN=) value. When you are finished, enter a zero.

Example:        You are doing a number of analyses, anchoring a few, but different, items each analysis. You don't want to create a lot of small anchor files, but rather just enter the numbers at the terminal, so specify:

       IANCHQ=Y

       CONVERGE=L                ; only logit change is used for convergence

       LCONV=0.005                ; logit change too small to appear on any report.

You want to anchor items 4 and 8.

WINSTEPS asks you:

DO YOU WANT TO ANCHOR ANY ITEMS?

respond YES(Enter)

DO YOU WISH TO READ THE ANCHORED ITEMS FROM A FILE?

respond NO(Enter)

INPUT ITEM TO ANCHOR (0 TO END):

respond 4(Enter) (the first item to be anchored)

INPUT VALUE AT WHICH TO ANCHOR ITEM:

respond 1.45(Enter) (the first anchor value)

INPUT ITEM TO ANCHOR (0 TO END): 8(Enter)

INPUT VALUE AT WHICH TO ANCHOR ITEM:-0.23(Enter)

INPUT ITEM TO ANCHOR (0 TO END): 0(Enter) (to end anchoring)